欢迎!

分享和讨论最佳内容和新营销理念,打造专业形象,共同成为更好的营销人员。

注册

You need to be registered to interact with the community.
This question has been flagged
11 Views

Range is set by the link budget, and in water the dominant term is frequency-dependent absorption, not the transmitter power you can buy.

The four limits, in the order they usually bite:

  • Absorption. Seawater attenuates sound strongly, and the loss rises steeply with frequency. Doubling the frequency can cut usable range by a large factor, which is why long-range links use low carriers and accept low data rates.
  • Ambient noise. Shipping, wind, rain and biologics raise the noise floor; the receiver's usable signal-to-noise ratio, not the source level alone, decides the link.
  • Multipath. In shallow water the same transmission arrives many times with different delays. Beyond a certain range the delay spread exceeds the symbol period and the link fails unless the receiver equalises or the waveform carries guard time.
  • Platform and geometry. A near-surface link suffers surface reflection and bubble loss; a link across a thermocline suffers refraction and shadow zones.

Practical consequence: specify range and data rate together. A 1 km link at a few hundred bits per second and a 100 m link at tens of kilobits per second are different products, not different settings of the same product.

Related: high-rate modem configurations and deployment reports with measured ranges.

Avatar
Discard